Separating efficiency of small copper wire recycling machine

Small copper wire recycling machine is a waste processing equipment that many users prefer. It has a small area, but it has complete functions, simple operation and good stability. The editor analyzes the sorting effect of the small copper wire recycling machine with a small investment.

1. In a trial production, the feeding should be controlled at about 50%-60% of the machine's output. After 3-5 hours of continuous production, the feeding should be controlled at about 50%-60% of the machine's output. After 3-5 hours of continuous production, the feeding should be based on a 10% increase in the output of each machine every 3-5 hours, and it must not be fed at full load from the beginning, because each machine needs to be run-in.

2. The dry copper wire recycling machine is filled with new grease every 40 hours of operation, and the bearing of the crusher is filled with new grease every 8 hours of operation. 3# calcium-based grease is selected for the lubricating grease.

3. During the production process, the raw materials should be broken separately, copper wire and aluminum wire should not be mixed, and the diameter of each batch of broken raw materials should be the same. The mixing of thick and thin lines will affect the sorting efficiency. When debugging, the feeding amount should be controlled at about 30% of the output of the machine, so as to avoid the untimely adjustment of the single machine and the accumulation of materials at the rear of the machine. The speed of the frequency converter of the lower blower is adjusted to between 35-40Hz, which is increased or decreased according to the sorting situation. The speed frequency of the frequency converter of the vibration sorting motor is adjusted to between 28-35Hz, which is increased or decreased according to the sorting situation.

Suny Group : http://www.sunyrecycle.com/，All rights reserved。